TheoryFree ASE T6 Truck Electrical Prep Practice Test PDF
Download a free ASE T6 Truck Electrical Prep practice test PDF with 30 questions, answers and explanations, then continue with online mock exams.
Free ASE T6 Truck Electrical Prep PDF with 30 questions
Print it, save it, or use it as a quick cram sheet before taking a timed mock exam.
Download PDF
The PDF includes 30 ASE T6 Truck Electrical Prep questions with answers and explanations.
Try ASE T6 Truck Electrical Prep questions now
Q1When diagnosing a circuit with a blown fuse, which of these tools is MOST effective for finding the short to ground?
Show answer
✓ Correct answer: Digital multimeter (ohms)
A digital multimeter set to measure ohms is the most effective tool for finding a short to ground. By disconnecting components and measuring resistance to ground, a technician can isolate which component or section of wiring is causing the short.
Q2A truck's dash lights flicker intermittently while driving. Technician A says this could be caused by a loose battery connection. Technician B says this could be caused by a faulty alternator. Who is right?
Show answer
✓ Correct answer: Both A and B
Both technicians are correct. A loose battery connection can cause voltage fluctuations in the electrical system, resulting in flickering lights. Similarly, a faulty alternator that produces inconsistent output voltage would cause the same symptom.
Q3What is the proper way to measure voltage drop across a switch in a circuit?
Show answer
✓ Correct answer: Place meter leads on both sides of the switch with the circuit energized
To properly measure voltage drop across a switch, the circuit must be energized (on) with current flowing through it, and the multimeter leads must be placed on both sides of the switch simultaneously.
Q4When testing a truck that has a parasitic draw of 2.5 amps, what is the BEST next step?
Show answer
✓ Correct answer: Pull fuses one at a time while monitoring amperage
A parasitic draw of 2.5 amps is excessive and will quickly drain the battery. The best next step is to pull fuses one at a time while monitoring the amperage to isolate which circuit is causing the excessive draw.
Q5When diagnosing an open circuit, a technician connects one lead of an ohmmeter to one end of the circuit and the other lead to the opposite end. The meter reads OL (infinite resistance). What does this indicate?
Show answer
✓ Correct answer: There is an open somewhere in the circuit
An OL (infinite resistance) reading indicates there is no complete path for current to flow, confirming an open circuit exists somewhere between the two test points.
Q6What is the correct way to test a relay using a digital multimeter?
Show answer
✓ Correct answer: Check coil resistance and test continuity of contacts
To properly test a relay with a DMM, you should check coil resistance by measuring across the control terminals, and then verify continuity of the switch contacts both in their normal state and when the coil is energized.
Full ASE T6 Truck Electrical Prep bank + unlimited mocks
Try 30 questions free. Unlock the complete ASE T6 Truck Electrical Prep question bank, every explanation, and unlimited timed mock exams. Practice on any device.
Unlock ASE T6 Truck Electrical Prep →