TheoryWhite Card (CPCCWHS1001)
Practice Test
136 authentic construction-induction questions so you walk into your White Card assessment ready.
Heads up: the app and the web exam use separate accounts — a web unlock and an in-app purchase do not carry over. Buy on the web to practice on the web.
30 free White Card (CPCCWHS1001) questions
Sampled across every topic area — not just the first page. Try them as a quiz or flip them as flashcards.
-
Hazard Identification & Risk Control
What is the hierarchy of controls listed from most to least effective?
Correct — A. The hierarchy starts with the most effective—Elimination—and ends with the least effective—PPE. -
Hazard Identification & Risk Control
A 'hazard' on a construction site is best defined as:
Correct — A. A hazard is anything with the potential to cause harm, before any injury occurs. -
Hazard Identification & Risk Control
Which document formally identifies hazards and describes control measures for a specific high-risk task?
Correct — A. A SWMS is required for high-risk construction work and outlines hazards and controls step-by-step. -
Hazard Identification & Risk Control
Before starting work in a new area of a construction site, what should you do?
Correct — A. Always inspect the work area for hazards before commencing work to prevent incidents. -
Hazard Identification & Risk Control
What does a 'risk assessment' involve?
Correct — A. A risk assessment systematically identifies hazards and evaluates and controls risks. -
Hazard Identification & Risk Control
You notice a colleague is about to use a damaged power tool. What should you do?
Correct — A. Damaged equipment must be taken out of service immediately using a tag-out procedure. -
Hazard Identification & Risk Control
Which of the following is an example of an administrative control?
Correct — A. Job rotation is an administrative control; it does not eliminate the hazard but reduces exposure. -
Hazard Identification & Risk Control
On a construction site, housekeeping hazards (e.g. clutter, spills) most commonly cause which type of incident?
Correct — A. Poor housekeeping creates slip and trip hazards, the most frequent cause of same-level falls. -
Hazard Identification & Risk Control
What should you do if you identify a hazard that you cannot control yourself?
Correct — A. Hazards beyond your control must be reported promptly so a competent person can address them. -
Hazard Identification & Risk Control
Which risk control measure removes the hazard entirely?
Correct — A. Elimination removes the hazard from the workplace altogether and is the most effective control. -
Hazard Identification & Risk Control
A 'residual risk' is best described as:
Correct — A. Residual risk is what remains after implementing control measures; it should be as low as reasonably practicable. -
Hazard Identification & Risk Control
Who is primarily responsible for identifying and managing hazards on a construction site?
Correct — A. WHS legislation places shared duties on all persons—workers, supervisors, and management. -
Hazard Identification & Risk Control
What does 'ALARP' stand for in WHS risk management?
Correct — A. ALARP means risks must be reduced to a level as low as reasonably practicable given cost and practicality. -
Hazard Identification & Risk Control
Which of the following best describes a 'near miss'?
Correct — A. Near misses are important warning signs and must be reported to prevent future incidents. -
Hazard Identification & Risk Control
When using a ladder, which risk is classified as a 'working at heights' hazard?
Correct — A. Falls from ladders are a working-at-heights hazard requiring appropriate controls. -
Hazard Identification & Risk Control
What is the purpose of a site safety induction?
Correct — A. Site inductions ensure every worker understands the hazards, controls, and emergency procedures specific to that site. -
Hazard Identification & Risk Control
A Risk Priority Number (RPN) combines which two factors?
Correct — A. Risk is the product of likelihood and consequence (severity), used to prioritise controls. -
Hazard Identification & Risk Control
Which colour is universally used on construction sites to indicate 'danger – do not use'?
Correct — A. Red is the danger colour; red tags on equipment mean it is out of service and must not be used. -
Hazard Identification & Risk Control
What is the main purpose of a toolbox talk (safety meeting)?
Correct — A. Toolbox talks keep hazard awareness high by reviewing daily risks and safe procedures before work begins. -
Hazard Identification & Risk Control
If you are unsure whether a task is safe to perform, you should:
Correct — A. If in doubt, stop. WHS law gives workers the right to cease unsafe work until it is made safe. -
Personal Protective Equipment
What is the primary limitation of PPE as a risk control measure?
Correct — A. PPE is the last resort—it protects only the user and does not reduce the hazard at its source. -
Personal Protective Equipment
Which type of hard hat is required when working near overhead electrical hazards?
Correct — A. Class E hard hats are designed to reduce electrical hazards and are required near live conductors. -
Personal Protective Equipment
Safety footwear on a construction site must include:
Correct — A. Steel-capped, puncture-resistant boots protect against crushing, sharp objects, and penetration hazards. -
Personal Protective Equipment
When must safety glasses or goggles be worn?
Correct — A. Eye protection is required any time there is potential for eye injury; this includes grinding, cutting, and chemical handling. -
Personal Protective Equipment
If your hard hat has a crack in the shell, you should:
Correct — A. A cracked hard hat cannot provide rated protection and must be replaced straight away. -
Personal Protective Equipment
High-visibility (hi-vis) clothing is required on construction sites primarily to:
Correct — A. Hi-vis garments ensure workers are seen by operators of vehicles and plant, reducing struck-by incidents. -
Personal Protective Equipment
Which respiratory protection should be selected when working with fine silica dust?
Correct — A. Silica dust is a serious respiratory hazard; a P2/N95 respirator provides the necessary filtration efficiency. -
Personal Protective Equipment
Before using a fall arrest harness, a worker should:
Correct — A. Harnesses must be inspected before each use; a damaged or expired harness must not be used. -
Personal Protective Equipment
Hearing protection must be worn when noise levels exceed:
Correct — A. Australian WHS regulations require hearing protection when the daily noise exposure exceeds 85 dB(A). -
Personal Protective Equipment
The correct way to put on a dust mask to ensure a proper seal is to:
Correct — A. A fit check (pressure test) is essential to confirm the respirator seals correctly to your face.
White Card (CPCCWHS1001) sample questions
Tap any question below to reveal the answer and a plain-English explanation.
Personal Protective Equipment Sun protection on outdoor construction sites includes which combination?
A. SPF30+ sunscreen, hat with a brim, and UV-protective clothing ✓
B. Sunscreen only on the face
C. A hard hat alone is sufficient for sun protection
D. Sunglasses only
Correct — A. Outdoor workers need a combination of sunscreen, protective clothing, and shade to reduce UV exposure.
Working at Heights Under Australian WHS regulations, what height triggers 'high-risk construction work' requiring a SWMS?
A. 2 metres or more ✓
B. 1 metre or more
C. 3 metres or more
D. 4 metres or more
Correct — A. Work at 2 metres or above is classified as high-risk construction work requiring a SWMS.
Electrical Safety What colour are the active (live) wires in standard Australian three-phase electrical cabling (AS/NZS 3000)?
A. Brown, black, and grey ✓
B. Red, white, and blue
C. Black, red, and yellow
D. Green, orange, and purple
Correct — A. Post-2000 Australian wiring uses brown (active 1), black (active 2), and grey (active 3) for three-phase circuits.
Emergency Procedures & First Aid What is the emergency services number in Australia?
A. 000 ✓
B. 112
C. 999
D. 911
Correct — A. 000 is Australia's emergency number for police, fire, and ambulance services.
Rights, Duties & WHS Legislation The Work Health and Safety Act 2011 imposes a duty of care on which of the following?
A. All persons at a workplace, including workers, employers, designers, and manufacturers ✓
B. Only employers and principal contractors
C. Only licensed tradespeople
D. Only the principal contractor and the government
Correct — A. The WHS Act 2011 covers all persons conducting a business or undertaking (PCBUs) and workers, creating shared duties.
Hazardous Substances & GHS Under the Globally Harmonised System (GHS), where would you find detailed information about a hazardous chemical's health effects and safe handling?
A. Safety Data Sheet (SDS) ✓
B. Material certificate of conformance
C. Delivery docket
D. Product marketing brochure
Correct — A. The SDS (formerly MSDS) contains 16 standardised sections covering health hazards, PPE, storage, and spill response.
Manual Tasks, Noise & Site Signs The primary risk associated with manual tasks (e.g. lifting, carrying, pushing) is:
A. Musculoskeletal disorders (MSDs) such as strains, sprains, and back injuries ✓
B. Respiratory disease
C. Electric shock
D. Chemical burns
Correct — A. MSDs are the most common outcome of hazardous manual tasks; they affect muscles, tendons, nerves, and joints.
Real Exam Practice What does the abbreviation 'WHS' stand for in the Australian construction industry?
A. Workplace Hazard Standards
B. Work Health and Safety ✓
C. Worker Housing Scheme
D. Workforce Health Services
Correct — B. WHS stands for Work Health and Safety. Australia's harmonised laws are the model WHS Act and WHS Regulations.
About the White Card (CPCCWHS1001) test
Get ready for your Australian construction White Card the calm, thorough way - with 130+ practice questions covering the General Construction Induction (CPCWHS1001).
What you get
- 130+ practice questions covering work health and safety duties, hazards, risk control, signage, PPE and emergency procedures on a construction site.
- Plain-language explanations for every correct answer - understand the safety reason, don't just memorise.
- Timed mock exam in a realistic format so you walk in confident.
- Study by topic to reinforce your weak spots.
You will be tested on
- Work health & safety law and duty of care
- Spotting site hazards and controlling risk
- Personal protective equipment (PPE)
- Emergency procedures and incident reporting
How TheoryPractice helps you pass
- Real exam-style questions with instant, detailed explanations
- Full timed mock exams that mirror the real test format
- Flashcards & quiz modes from the same question bank
- Progress tracking so you know exactly when you're ready
Topics in this question bank
Work health & safety law and duty of care
Spotting site hazards and controlling risk
Personal protective equipment (PPE)
Emergency procedures and incident reporting
Full White Card (CPCCWHS1001) bank + unlimited mocks
Try 30 questions free. Unlock the complete White Card (CPCCWHS1001) question bank, every explanation, and unlimited timed mock exams. Practice on any device.
Unlock White Card (CPCCWHS1001) →